I have pounded it with a 5 pound hammer, a 10 pound sledge, it ain't moving.

BOLT, SWINGARM PIVOT Part Number: 90121-HN1-000 Required per assembly: 1:.

Is this good enough or to tight. You could put it on with the swingarm in place, but why not do it now when it'll be a little easier.

Was the biggest pain in the ass I have ever encountered removing the swingarm bolt.

You may have to.

Don't forget the rubber chain touch defense. . (792–880N) for a new belt.

Swingarm.

Discussion Starter · Sep 14, 2013. 35. 1988 Honda TRX 250R, Duncan Racing National Kit, Gussetted Stock Frame, Laeger.

9: Swingarm Pivot Bolt (left) 1: 30: 87: Swingarm Right Pivot Lock Nut: 1: 30: 87: Final Gear Case Mounting Flange Bolt: 8: 10: 40:. .

Diagram.

.

3. manual says to torque to 80 ft pounds(108 N*m) 06-19-2008, 07:57 PM #4.

This accepts the ROUND STYLE BEARING CARRIER. .

class=" fc-falcon">This is an atv quad 4-wheeler rebuild.
This is what I had to do to get my quad going again, and the kit I ordered from JE Honda to replace the damaged parts.
Shipping calculated at checkout.

.

.

Honda 400EX Swing Arm. Jul 28, 2007 · Use a hammer and a drift to knock the bolt out, be sure to not destroy the end of the bolt, BUT! Most likely you will need to get a new one. ATV.

Also, anyone know the torque for the bolt attaching the rear shock to the linkage? Mitch 00 400EX, FMF pipe, busted works shocks. All are Nm. In the fall I decided to pull the Pivot Bolt for the swingarm, just on spec. Jul 28, 2007 · Use a hammer and a drift to knock the bolt out, be sure to not destroy the end of the bolt, BUT! Most likely you will need to get a new one. Lol. fc-falcon">817 subscribers.

Honda TRX90.

the bolt should be removable. Including Cylinder Head torques, Lugnuts, Wheel Hub, Oil Drain Plug torques,.

Also, anyone know the torque for the bolt attaching the rear shock to the linkage? Mitch 00 400EX, FMF pipe, busted works shocks.

.

.

Here's the swingarm assembled and ready to go back into place.

You may have to.